Waist measurement

How to Measure Waist Circumference Correctly

To measure your waist, stand up and find the midpoint between your lowest rib and the top of your hip bone. Wrap a tape measure around that line against bare skin, keep it level, and read it at the end of a normal breath out. In Australia, 94cm for men and 80cm for women indicate increased risk.

If weight, food or numbers start to feel hard

Food, weight and numbers can start to feel stressful. If that happens, tell your doctor or another health professional you trust. Free, confidential help is also there. Call the Butterfly Foundation National Helpline on 1800 33 4673, open 8am to midnight AEST, 7 days. Call Lifeline on 13 11 14, any hour.

What You Need Before You Start

Very little, and that is part of the appeal.

You need a flexible tape measure, the kind used for sewing. A metal builder's tape will not sit flat against the body and will give a reading that is too small. If you do not own one, a length of string and a ruler works. Mark the string where it meets, lay it flat, and measure it.

You also need to be able to reach bare skin. Clothing adds between one and three centimetres depending on the fabric, and the error is not consistent from day to day.

How to Measure Your Waist, Step by Step

Six steps, about two minutes.

1

Stand up straight with your feet about 25 to 30cm apart. Keep your weight even on both feet.

2

Find the bottom of your lowest rib on one side, then the top of your hip bone below it. The midpoint between them is the measuring line.

3

Wrap the tape around your body at that line, against your skin.

4

Check the tape is level all the way round. Use a mirror, or ask someone to look at your back.

5

Breathe out normally and stop. Do not hold your breath or pull your stomach in.

6

Read the tape where it meets, snug but not pressing into the skin, and write the number down.

Measure twice. If the two readings are more than 1cm apart, measure a third time and take the middle value.

Where Exactly Is the Waistline?

This is the question that causes the most confusion, because there are two answers in use.

The midpoint between the lowest rib and the top of the hip bone is the method the World Health Organization describes. Most Australian clinical guidance follows it. For most adults this sits a little above the navel.

The navel itself is the other common landmark, and it is the one most home guides use because it is easy to find. It usually gives a slightly larger number.

Either will work as long as you use the same one every time. The reading matters less than the comparison between readings, and a landmark that moves makes the comparison meaningless. If a nurse or doctor is going to record the figure, use the rib-to-hip midpoint, because that is what the cut-offs below were built on.

Australian Waist Measurement Cut-Offs

Two thresholds, each with a different meaning, and they differ by sex.

For men

A waist of 94cm or more indicates increased health risk. A waist of 102cm or more indicates substantially increased risk.

For women

A waist of 80cm or more indicates increased health risk. A waist of 88cm or more indicates substantially increased risk.

Healthdirect publishes these figures alongside the BMI bands. They describe risk across a population, not a diagnosis for one person, in the same way BMI does.

These numbers apply to adults. They are not used for children, and a waist measurement taken during pregnancy is not meaningful.

Lower Cut-Offs for Some Backgrounds

Risk appears at a smaller waist in several populations, so the thresholds shift down.

For South Asian, Chinese, other Asian, Middle Eastern and Black African backgrounds, the figures commonly used are 90cm for men and 80cm for women. The pattern matches the lower BMI thresholds on the BMI ethnicity guidelines page. The reason is the same: body size and metabolic risk do not line up identically across populations.

Five Mistakes That Change the Number

Each one is easy to make and each one moves the reading by a centimetre or more.

Measuring over clothes

Adds one to three centimetres, and the amount changes with what you are wearing.

Pulling the tape tight

Compresses the skin and makes the figure smaller than it is. Snug means the tape stays in place when you let go.

Holding your breath or breathing in

Expands the ribcage and the abdomen. Measure at the end of a normal breath out.

A tape that slopes

The back is the part people cannot see, and it is usually where the tape rides up. Check it in a mirror.

Measuring at different times of day

Abdominal size changes after meals and across the day. Morning, before eating, is the most consistent choice.

How Often Should You Measure?

Less often than most people think.

Waist circumference moves slowly. Measuring daily produces a string of numbers that mostly reflect meals, fluid and measuring error rather than any real change. Every four to six weeks is enough to see a trend, and that trend is the useful part.

Keep the conditions the same each time. Same landmark, same time of day, same tape, bare skin. A measurement taken under different conditions cannot be compared with the one before it.

Why Waist Adds Something BMI Cannot

The two measures answer different questions, which is why Australian guidance uses both.

BMI describes how much you weigh relative to your height. It cannot tell where that weight sits. A waist measurement describes exactly that, and fat carried around the abdomen behaves differently from fat carried elsewhere.

This is why two people with the same BMI can sit in different risk categories. A BMI of 27 with a waist of 85cm and one with a waist of 105cm describe different bodies. Only the waist measurement tells them apart. The visceral fat page covers what the abdominal measurement is actually picking up.

Key point

Waist is also the input for two ratios that some clinicians prefer. The waist-to-height ratio compares your waist with your height, with 0.5 as the usual reference point. The waist-to-hip ratio compares your waist with your hips.

Measuring Someone Else, or Measuring Alone

Both are workable, with one adjustment each.

Measuring alone, the back is the problem. Stand side-on to a mirror so you can check the tape is level behind you. You can also feel along the tape with your free hand to confirm it has not slipped.

Measuring someone else, stand beside them rather than in front. Standing in front encourages you to pull the tape towards yourself, which tilts it. Ask them to breathe normally and take the reading on the breath out, not on a held breath.

Key point

If the person cannot stand, a lying measurement can be taken, but it will not be comparable with a standing one. The mobility adjustments page covers measuring when standing is not possible.

Questions About Measuring Your Waist

Either works if you are consistent. The midpoint between your lowest rib and the top of your hip bone is the method behind the published cut-offs. It usually sits slightly above the navel. The navel is easier to find and gives a marginally larger reading. Pick one and use it every time.

Out, and normally. Take a normal breath, let it out, and read the tape before you breathe in again. Holding a breath in expands the abdomen and inflates the reading. Pulling your stomach in does the same in reverse.

Below 94cm for men and below 80cm for women is the range associated with lower risk. Above those figures indicates increased risk, and 102cm for men or 88cm for women indicates substantially increased risk. Lower thresholds apply for several population backgrounds.

Food, fluid and the time of day all change abdominal size by a centimetre or more. Measuring error adds another centimetre on top of that. This is why a single reading means little and a trend across several weeks means a great deal.

No. The two are used together, because they describe different things. BMI gives a size relative to height and waist gives the distribution. Australian guidance asks for both, and a BMI calculation alongside a waist reading is more informative than either figure alone.

Check where you sit

Calculate your BMI

BMI Calculator

Your body mass index and the WHO category it falls in.

cm
kg
24.2Healthy weight

Example shown: height 170 cm, weight 70 kg. Change the numbers to see your own result.

This is a screening tool, not a diagnosis.

Calculator ecosystem

Popular calculators & tools